Instruction Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Procedures of Assembly/Disassembly
- Chapter 3 Board Introduction
- Chapter 4 H/W Information
- Chapter 5 BIOS Settings
- SATA Configuration
- W83627DHG Super IO Configuration
- Serial Port Console Redirection
- Intel(R) 82576 Gigabit Dual Port Network Connection
- N/A
- Configure Gigabit Ethernet device parameters
- Intel(R) 82574L Gigabit Network Connection
- N/A
- Configure Gigabit Ethernet device parameters
- SATA Mode Selection
- Port 1
- Port 2
- CF card
- COM1 Configuration
- COM2 Configuration
- LAN by Pass Function
- Change Settings
- Serial Port
- Change Settings
- Device Mode
- Console Redirection
- Console Redirection Settings
- EMS
- EMS Settings
- Terminal Type
- Bits per second
- Data Bits
- Parity
- Stop Bits
- Flow Control
- NIC Configuration
- Blink LEDs (range 0-1
- Link Status
- NIC Configuration
- Blink LEDs (range 0-1
- Link Status
- SYS temperature
- CPU temperature
- CPU Fan Speed
- VCORE
- LAN1 ~ 8
- USB Configuration
- xHCI Mode
- EHCI1
- Setup Prompt Timeout
- Boot up NumLock State
- Boot Logo
- PXE Function
7.2.2 Watchdog
On Linux platform:
1. Libw83627.h
This file includes the declarations of the APIs and macro definitions.
2. maintest.c
The source code of the utility.
On Windows platform:
1. IB75N.h
The header file of the APIs.
2. IB75N.lib and IB75N.dll
The API libiaries.
7.2.3 LAN Bypass Subsystem
On Linux platform:
1. bypass.h
This file includes the declarations of the APIs and macro definitions.
2. main.c
The source code of the utility.
On Windows platform:
1. IB75N.h
The header file of the APIs.
2. IB75N.lib and IB75N.dll
The API libiaries.
68