Owner's manual

A
A
R
R
-
-
B
B
1
1
3
3
2
2
0
0
U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
4-5
BootUp Num-Lock
This item is used to activate the Num-Lock function upon system boot. If the setting is on, after a boot,
the Num-Lock light is lit, and user can use the number key.
Available options: On, Off
Floppy Drive Swap
The option reverses the drive letter assignments of your floppy disk drives in the Swap A, B setting;
otherwise leave on the default setting of disabled (No Swap). This works separately from the BIOS
Features floppy disk swap feature. It is functionally the same as physically interchanging the
connectors of the floppy disk drives. When <Enabled>, the BIOS swap floppy drive assignments so
that Drive A becomes Drive B, and Drive B becomes Drive A under DOS.
Available options: Disabled, Enabled
Floppy Drive Seek
If the <Floppy Drive Seek> item is set to Enabled, the BIOS will seek the floppy <A> drive one time
upon boot-up.
Available options: Disabled, Enabled
Typematic Rate
This item specifies the speed at which a keyboard keystroke is repeated.
Available options: Fast, Slow
System Keyboard
This function specifies that a keyboard is attached to the computer.
Available options: Absent, Present
Primary Display
The option is used to set the type of video display card installed in the system.
Available options: Absent, VGA/EGA, CGA40x25, CGA80x25
Password Check
This option enables password checking every time the computer is powered on or every time the BIOS
Setup is executed. If Always is chosen, a user password prompt appears every time the computer is
turned on. If Setup is chosen, the password prompt appears if the BIOS is executed.
Available options: Setup, Always
Wait for ‘F1’ If Error
AMIBIOS POST error messages are followed by:
Press <F1> to continue
If this option is set to Disabled, the AMIBIOS does not wait for you to press the <F1> key after an error
message.
Available options: Disabled, Enabled