User's Manual

W
W
i
i
F
F
i
i
V
V
o
o
I
I
P
P
P
P
h
h
o
o
n
n
e
e
3. OPERATIONS
This chaper describes how to operate and configure the AVP-2000B WiFi Phone.
3.1 POWER ON / OFF
3.1.1 Power On
Press [ ] button during 2 or 3 seconds to power on the AVP-2000B, then AVP-2000B
turn on the power with short beep sound.
3.1.2 Power Off
Press [ ] button during 2 or 3 seconds to power off the AVP-2000B, then AVP-2000B
turn off with “Good-Bye” message on LCD windows.
3.2 SIP REGISTRATION / UNREGISTRATION
3.2.1 REGISTRATION
AVP-2000B can use after SIP registration operation on SIP REGISTRAR SERVER.
The operations of SIP registration are as below ;
1) Press [M] button in standby state.
2) Select “4.Admin Setup” menu.
3) Default password is “0000”.
4) First, select “1. Setup Network” menu and configure the network informations.
AVP-2000B supports two kind of IP address mode which are DHCP mode and Static IP
address mode. When used as Static IP address mode, SubNet Mask value and Default
Gateway Address are also needed.
(Refer to clause 4.2 how to input IP address)
5) Select “2. Setup SIP” menu and configure the SIP informations.
AVP-2000B need some SIP informations to make / receive call.
- SIP Phone Number - Administrator will be supported
- SIP Registrar Server IP Address - Administrator will be supported
- SIP Domain Name – Administrator will be supported.
(SIP Registrar Server IP Address will be used as default value if not supported.)
- SIP Authenticate Name – Administrator will be supported
9