User's Manual

!AcroLAN Card User’s Guide Version 20002.5

Page 28 of 38

usually, the quality level moves simultaneous with the Link Quality level.

Network Type : You can select wireless LAN network mode – Infrastructure(Access

Point) or Ad-hoc(Peer-to-Peer) mode

Infrastructure Mode

This mode is used to set up a connection to a wired Ethernet network. This mode

requires an ACROLAN Access Point to gain access to the wired network.

Ad Hoc Mode

This mode is used to set up a small, temporary network between two or more

computers. For example, you might set up an ad hoc network between computers in a

conference room so users can share information in a meeting.

Network Name(SSID) : The Service Set Identifier (SSID) controls access to a given wireless

network. This value MUST match the SSID of any and all AcroLAN Access Points that you want

to communicate with. If the value does not match, access to the system is not granted. The SSID

can be up to 32 case-sensitive characters.

Transmit Rate: The transmission rate at which the data packets are transmitted by the

client or AP. You can set this value to 1~2Mbps, 5.5Mbps, 11Mbps or Fully Automatic.

Power Save Enabled : Power Saving Mode. Currently, the Power Save mode does not

supported.

After changing the setting in the Configuration change dialog box, click on Apply

Changes button. It takes a few seconds to set changes that you made.

Network Configuration

Network ConfigurationNetwork Configuration

Network Configuration