Wireless Multimedia Keyboard & Mouse w/Nano Receiver USER'S GUIDE Ver.:1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction Mouse Buttons 5. Battery Cover 6. Connect Button 7. ON/OFF Switch 8. Nano Receiver 1. Left Button 2. Right Button 3. Scrolling Wheel 4.
Key Function (* compound key, Press with Fn key) 1. Media Player On Turn on the Media player program 2 Volume down (Voice-) Decrease the computer's sound volume. 3. Volume up (Voice+) Increase the computer's sound volume. 4. Mute Mute (turns off) the computer's sound 5. Previous Switch to the previous media track 6. Next Switch to the next media track 7. Play/Pause 8. Stop(Media) 9. Homepage(www/e) 10. Outlook(E-mail)Default Start the default e-mail program 11.
Number Lock Indicator 13. Caps Lock Indicator Low Battery & Pairing Indicator 14. Battery Cover Fn + HOME Fn + END Fn + Pg UP Fn + Pg DN Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment.
AAA Battery X 2 Step 3: Replace the cover. Step 4: Turn on power switch. **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse & Keyboard.
Setup the Connection between the Receiver and the Mouse & Keyboard 1. Remove the cover under the mouse & keyboard to access the battery and nano receiver compartment. 2. Insert batteries into the mouse & keyboard, and remove the nano receiver from the compartment. Place the covers back onto the devices. 3. Plug the nano receiver into a USB port on your computer. 4. If the device does not work, please turn it into pairing mode. 5.
after 10 seconds, pair them again. (The receiver has auto pairing functionality).. 6. The LED indicator on the mouse & Keyboard flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. 7. When the device has low battery, the battery indicator on the keyboard or the mouse will start to blink. *Mouse Indicator LED Indicator LED is on for 10 sec. Power ON LED Blinking During Pairing (LED OFF when paired or failed after 10 sec.) LED Blinks for 10 sec.
