User Manual

ManualsBrandsAcrox Technologies ManualsComputers & Accessories2.4G NANO MOUSE

2.4GHz Wireless

Hi-Low Laser Mouse

w/Nano Receiver

USER'S GUIDE

Ver.:1.00

CAUTION: To use this product properly, please read the user's guide before installation

Please DO NOT direct the laser beam at anyone’s eye.

Safety Notice

1 This product complies with IEC 60825-1,

class 1 laser product.

2 Your product complies with FCC and CE rules.

3 This product has no serviceable parts. Use of

controls or adjustments of procedures other than

the user guide may result in danger.

Summary of content (5 pages)

PAGE 1
2.4GHz Wireless Hi-Low Laser Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 Safety Notice 1 This product complies with IEC 60825-1, class 1 laser product. 2 Your product complies with FCC and CE rules. 3 This product has no serviceable parts. Use of controls or adjustments of procedures other than the user guide may result in danger. Please DO NOT direct the laser beam at anyone’s eye.
PAGE 2
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Functional Introduction ON/OFF Switch Low Battery / Pairing indicator Metal Wheel Right button Left button Connect Button Nano Receiver Hi-Low Button Battery and Power Management: Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover.
PAGE 4
Hi-Low Introduction The perfect design for notebook users. This ultra slim, super small mouse is ideal for on-the-go users, and can be used comfortably anywhere, any time Hi position Nano Receiver Low position Push Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2.
PAGE 5
3. Push out the Nano Receiver in the back of mouse then plug into your PC/Laptop. 4. If the mouse is not working, please put it into pair mode. 5. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect buttons on the mouse. If the mouse does not work after 30 seconds, pair them again. (The receiver has auto pairing function). 6.The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver.