Mini RF Laser Mouse OWNER'S GUIDE CAUTION : To use this product properly, please read the user's guide before installation
Welcome Your mouse uses a new generation technology – laser module that replaces the traditional LED mouse and provides amazing tracking ability. The laser module accurately scans the surface in 30 times sensitive of LED optical mouse. You can work with your mouse in most surfaces perfectly. The mouse uses the digital radio technology as a convenient wireless application. Especially combine with a rechargeable box for your mouse’s batteries; you can have the best compact solution to work with your notebook.
Installing the batteries Step 1 Press the tag on the bottom-end of mouse and pull the slide cover backward to remove the battery compartment cover. Step 2 Insert the batteries as shown inside the battery compartment. Step 3 Replace the cover.
Setup the connection Rf channel between the Mouse and the Receiver 1. 2. Press the ID Switch button on the Mouse Press the ID Switch button on the bottom of the Receiver If the mouse cursor does not move after 30 seconds, do above steps again. Push 1 Push 2 Caution: If you had completed the connection successfully, The LED on the receiver will be flash several times. If the ID Setting is not properly, please re set your ID again by following the above steps.
OR ANGE LED ON C ha rg ing b a tterie s GR EEN LED ON Finishe d c ha rg e / No b a tte rie s LED FLASH 0.5 sec. Regularly SEARC HING the c ha nne l LED FLASH if any action C ha nnel c o nne c te d LED ON No a c tion Using your mouse How to use the wheel Your mouse has a wheel that functions both as a wheel for Windows Scrolling and also as a customized button. It can be used as a standard mouse button, click (press down) the wheel. To Use the Middle Button, Directly Press down the Wheel.
Troubleshooting Mouse does not work upon installation Try one or more of the following: For optimal performance, place adjust the angle of the receiver to find the best performance. Make sure you have installed the batteries correctly. If you are working on a metallic surface, try using a mouse pad and Mouse not detected When using the mouse, it may not be detected by the computer, To remedy this problem, try the following Make sure the receiver is plugged into the right mouse port.
The Screen Cursors Does Not Move Properly Change the angle of your radio receiver,. Try adjusting the receiver and/or mouse to improve reception. Make sure that the battery low indicator is NOT lit on. Replace batteries if the low battery indicator is lit on. You may also need to change the channel / ID for the mouse, Press the Connect button on the receiver, then press the Connect button on the mouse. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
