BK4 Bluetooth Mouse OWNER'S GUIDE Ver.1.0 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction LED indicator Scrolling Wheel *Mouse Indicator Right button Red LED is on for 10 sec. Power ON Red LED Blinking Low battery Warning in working mode, LED will be off after 10 sec when mouse inactivity.
Battery and Power Management: Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment. Step 3: Replace the cover. 1st 2nd Pull AAA Battery **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. Power saving features: To conserve the battery power, the mouse offers power management functions as below: 1. The mouse goes into “Saving Mode” after inactivity. 2.
Device (HID) profile. If your computer does not support Bluetooth, you need to obtain and install a commercially available Bluetooth dongle which converts your computer to a Bluetooth environment. Troubleshooting A. Mouse does not work upon installation or is not detected Try one or more of the following: Make sure the batteries are installed correctly and turn the switch on. Replace a fresh set of batteries if it still does not work. Verify that the computer is Bluetooth enabled.
connected to your computer. Switch off any other devices operating in the 2.4 GHz radio spectrum, such as Wi-Fi network, mobile telephones, etc., or move their antennas further away from your computer.
