2.4GHz Wireless Ergo BlueTrace Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction Scrolling Wheel ON/OFF Switch LED Indicator Connect Button Right button Left button Battery Cover Nano Receiver Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Step 4: Turn on power switch. 1st 2nd Pull AAA Battery **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse.
Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano receiver out. 3. Plug the Nano receiver into the USB port on your computer. GREEN LED FLASH (0.5 sec. Regularly) Se a rc hing the c ha nne l GREEN LED FLASH (if any action) Cha nnel c o nnec te d GREEN LED ON No a c tio n Connec t to the USB or Mouse port of your c omputer 4.
*Mouse Indicator LED Indicator LED is on for 3 sec. Power ON LED Blinks for 3 times During Pairing (LED OFF when paired or failed after 10 sec.) LED Blinks for 10 sec.