2.4GHz Wireless Optical Mouse USER'S GUIDE Ver.:1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction 2
Battery and Power Management: Installing the batteries Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. For Extra usage hours, use two AA batteries instead of two AAA Batteries. Setup the Connection between the Receiver and the Mouse 1. Plug the RF receiver into the USB port of your computer.
2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pairing mode. 4. Pairing: Press the connect buttons on the receiver and mouse. If the mouse does not work after 30 seconds, pair the receiver and mouse again. 5.The LED indicator on receiver flashes steadily when it is in pairing mode and stops flashing when it is successfully paired with the mouse. The receiver remains steadily lit afterwards. 6.
