2.4G Standard Keyboard & Mouse USER'S GUIDE Ver.:1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction Connect Button Battery Cover Scrolling Wheel & LED Indicator LED Indicator Right button ON/OFF Switch Left button RF Receiver Battery and Power Management: Installing the batteries Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Push For Extra usage hours, use two AA batteries instead of two AAA Batteries.
Keyboard Buttons AAA battery X2 1. 2. 3.
Setup the Connection between the Receiver and the Mouse, Keyboard. 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse and keyboard, then follow the steps below. 3. If the mouse or the keyboard is not working, please put them into pair mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press connect button of the moue and keyboard. If the mouse or keyboard does not work after 10 seconds, pair them again.
*Receiver Indicator LED Indicator Green LED is on for 3 sec. Power ON Green LED Blinking (If any action) *Keyboard Indicator LED Indicator Red LED is on for 10 sec. Power ON Red LED Blinks for 10 sec. Low Battery Warning Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.