Wireless Stow-N-GoTM Laptop Mouse USER GUIDE
Wireless Stow-N-GoTM Laptop Mouse Wireless Stow-N-GoTM Laptop Mouse Introduction Congratulations on your purchase of the Targus Wireless Stow-N-GoTM Laptop Mouse. The Stow-N-GoTM receiver clips onto the mouse for ease of use while traveling or on the go. This is a plug and play device so no additional software is required. System Requirements Hardware • USB port Operating System • Windows® 2000 • Windows® XP • Windows Vista® • Mac OS® X v10.
Wireless Stow-N-GoTM Laptop Mouse Installing the Batteries 1. Remove the battery cover from the back of the mouse by sliding off the cover of the mouse. Hold the mouse in your hands and with the back of the mouse away from you. Press down on the corners of the battery cover and slide towards the back of the mouse. Lift the cover off from the back of the mouse. 2.
Wireless Stow-N-GoTM Laptop Mouse Establishing the Connection (A) Remove the USB receiver from the bottom of the mouse. (B) Plug the USB receiver into an available USB port on your computer. (C) Press and release the setup key on the receiver. (D) Press the setup key on the bottom of the mouse. This device has 256 identification codes that allow the mouse and its receiver to operate without interference from other radio frequency devices.
Wireless Stow-N-GoTM Laptop Mouse Product Specification Transmitter RF 2405MHz-2477MHz Battery Type Alkaline battery AA Effective RF Communication Range 10 meters max RF output power 94.47dBuV/m Receiver RF 2405MHz-2477MHz Interface USB 1.
Wireless Stow-N-GoTM Laptop Mouse Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
