Wireless Mouse AMW25US-30
Introduction Congratulations on your purchase of the Targus Wireless Stow-N-GoTM Laptop Mouse with Micro USB Receiver. The Stow-N-GoTM receiver clips onto the mouse for ease of use while traveling or on the go. This is a plug and play device so no additional software is required. System Requirements Hardware • USB port Operating System • Windows® 2000 • Windows® XP • Windows Vista® • Mac OS® X v10.
Installing the Batteries 1. Remove the battery cover from the back of the mouse by sliding off the cover of the mouse. Hold the mouse in your hands and with the back of the mouse away from you. Press down on the corners of the battery cover and slide towards the back of the mouse. Lift the cover off from the back of the mouse. 2. Insert two AA-size batteries, making sure that the positive (+) and negative (-) ends of each battery match the polarity indicators inside the battery compartment.
Establishing the Connection (A) Remove the USB receiver from the bottom of the mouse. (B) Plug the USB receiver into an available USB port on your computer. This mouse is a plug-n-play device. It should automatically operate when the USB receiver is connected to the computer.
If you experience interference during use or if the mouse doesn’t respond, follow the below steps to change the connection channel. (1) Unplug the micro USB receiver and plug it into another available USB port. (2) Press the connection button on the mouse. (3) If there’s still no response from the mouse, switch the mouse off, then switch the mouse back on again.
Product Specification Transmitter RF 2403MHz~2471MHz Battery Type Alkaline battery AA Effective RF Communication Range 10 meters max RF output power 76.66dBuV/m Receiver RF 2403MHz-2471MHz Interface USB 1.
Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
