User Manual

ACR38x (CCID) – Reference Manual [e-mail]
Version 6.04
www.acs.com.hk
Page 46 of 58
9.3.8. Memory Card – SLE 4404
9.3.8.1. SELECT_CARD_TYPE
This command powers up and down the selected card that is inserted in the card reader and performs
a card reset.
Note: This command can only be used after the logical smart card reader communication has been
established using the SCardConnect() API. For details of SCardConnect() API, please refer to PC/SC
specifications.
Command Format (abData field in the PC_to_RDR_XfrBlock)
Pseudo-APDU
CLA INS P1 P2 Lc Card Type
FFh A4h 00h 00h 01 08h
Response Data Format (abData field in the RDR_to_PC_DataBlock)
SW1 SW2
Where:
SW1 SW2 = 90 00h if no error
9.3.8.2. READ_MEMORY_CARD
Command Format (abData field in the PC_to_RDR_XfrBlock)
Pseudo-APDU
CLA INS P1 Byte Address MEM_L
FFh B0h 00h
Where:
Byte Address = Memory address location of the memory card
MEM_L Length of data to be read from the memory card
Response Data Format (abData field in the RDR_to_PC_DataBlock)
BYTE 1 … … BYTE N SW1 SW2
Where:
BYTE x Data read from memory card
SW1 SW2 = 90 00h if no error
9.3.8.3. WRITE_MEMORY_CARD
This command is used to write data to the specified address of the inserted card. The byte is written
to the card with LSB first, i.e., the bit at card address 0 is regarded as the LSB of byte 0.
The byte at the specified card address is not erased prior to the write operation and, hence, memory
bits can only be programmed from '1' to '0'.