User Manual

ACR38x (CCID) – Reference Manual [e-mail]
Version 6.04
www.acs.com.hk
Page 51 of 58
Command Format (abData field in the PC_to_RDR_XfrBlock)
Pseudo-APDU
CLA INS P1 Byte Address MEM_L Byte 1 .... .... Byte N
FFh D0h 00h
Where:
Byte Address Memory address location of the memory card
MEM_L Length of data to be written to the memory card
BYTE Byte value to be written to the card
Response Data Format (abData field in the RDR_to_PC_DataBlock)
SW1 SW2
Where:
SW1 SW2 = 90 00h if no error
9.3.9.4. ERASE_NON_APPLICATION_ZONE
This command is used to erase the data in Non-Application Zones. The EEPROM memory is
organized into 16-bit words. Although erases are performed on single bit, the ERASE operation clears
an entire word in the memory. Therefore, performing an ERASE on any bit in the word will clear ALL
16 bits of that word to the state of ‘1’.
To erase Error Counter or the data in Application Zones, please refer to the following:
1. ERASE_APPLICATION_ZONE_WITH_ERASE command as specified in Section 9.3.9.5.
2. ERASE_APPLICATION_ZONE_WITH_WRITE_AND_ERASE command as specified in
Section 9.3.9.6.
3. VERIFY_SECURITY_CODE commands as specified in Section 9.3.9.7.
Command Format (abData field in the PC_to_RDR_XfrBlock)
Pseudo-APDU
CLA INS P1 Byte Address MEM_L
FFh D2h 00h 00h
Where:
Byte Address Memory byte address location of the word to be erased
Response Data Format (abData field in the RDR_to_PC_DataBlock)
SW1 SW2
Where:
SW1 SW2 = 90 00h if no error