Specifications

ADT60/AET60 Reference Manual version 1.5 November 2005
7.2 Response
The response from the BioCARDKey/BioSIMKey to any command depends on whether the command has
been received by the reader without error (e.g., checksum error).
7.2.1 No transmission error with normal response (Length < 255 bytes)
The response by the BioCARDKey/BioSIMKey to a correctly received command consists of three protocol
bytes, two status bytes and a variable number of data bytes and has the following structure:
byte 1 2 3 4 5 ... N+4
(0<N<255)
N+5
Header SW1 SW2 Data length = N Data Checksum
Header Always 01
H
to indicate the start of the response.
SW1 Indicates the command execution status:
90
H
= command successfully executed
60
H
= error in command data; command cannot be executed
67
H
= error detected in command execution
FF
H
= status message initiated by the reader
SW2 Further qualification of the command execution status.
A table listing the possible values of the status bytes SW1 and SW2 and the corresponding
meaning is given in Appendix B.
Data Length Number of subsequent data bytes (0 < N < 255)
Data Data contents of the command.
For a READ_DATA command, for example, the data bytes would contain the contents of
the memory addresses read from the card. The data bytes can represent values read from
the card and/or status information.
Checksum The checksum is computed by XORing all response bytes including header, status bytes,
data length and all data bytes.
The following example shows the structure of the response to a command which has successfully been
executed and which returns three data bytes with the values 11
H
, 22
H
and 33
H
, respectively:
byte 1 2 3 4 5 6 7 8
01
H
90
H
00
H
03
H
11
H
22
H
33
H
92
H
 Advanced Card Systems Ltd. Page 10 of 25