User's Manual

4 –Pump 38-Station Controllers Chapter 4: Operation 26 of 44
Logging On and Logging Off
Your controller may be set up to require a password for any operation (other than reviewing
station and pump status, silencing alarms, reviewing the alarm log, and looking at help
screens). If so, touching a button will open the “Password Entry” keypad screen.
Figure 11: “Password Entry” Screen
Enter the four-digit password (including any leading zeros). For example, if the password is
1, enter 0001.
Each digit appears as an “
*
” as you touch it. When you touch the fourth digit, the controller
carries out your request. For example, it enables or disables the requested pump or station, or
it goes to the “Station Operator” screen. If you did not enter the correct password, the
controller erases the entry. You can then try again. To give up, touch Return.
Note: If you have lost the password(s), contact us for assistance.
Once you have logged on, the password remains active until the password expires. (Setup
personnel at your facility control the number of minutes before the password expires.) While
the password is active, you can continue to carry out password-protected tasks without
reentering the password. If the timer expires, the controller goes to the “Station Status” screen
and you must reenter the password to continue working.