User's Manual

2 –Pump 18-Station Controllers Chapter 3: Installation 19 of 44
Setting Up Pumps
Before starting the system, you must define several settings for each pump, such as how
quickly to shut it down when it is not in use. This section first discusses how to use the
controller’s menu system to configure pumps. The table on page 37 discusses the individual
choices. In order to setup up the pumps properly, perform the following:
1. Go to the “Pump Status“ screen if needed. To reach this screen, touch the PUMP
STATUS button on the Main Menu. The “Pump Status” screen appears:
Figure 8: “Pump Status” Screen
2. Touch the icon for the pump you want to set up, and hold it for several seconds. The
“Pump Setup” screen opens.
Figure 9: Pump Setup Screen Before Setup
3. This screen shows you how long the pump has run (total hours) and provides you with
a resettable hour meter (Press HOUR METER RESET to clear the timer.). It also
provides you with the option of transferring pump operation to a standby pump. See
page 31 and 32 for specific setup instructions.
4. Press MORE to set up additional pump features. The second pump setup screen opens.
Figure 10: Second Pump Setup Screen
This display allows you to turn On or Off the Vacuum Pulse Filter Cleaner, Filter Can
Alarm, and the General Pump Fault. In addition, you can also set the amount of time
that the pump remains Idle. Press and hold the IDLE TIME button. The keypad will
open. The Idle Time feature can be set between 0 and 999 seconds.
5. Press MORE to set additional pump features. The third pump setup screen opens.