User's Manual

11
1
.
Fe
d
Int
e
AI6
0
d
eral
C
e
rfere
n
0
60
H
C
ommu
n
n
ce Sta
t
H
Us
e
-47-
n
icatio
n
t
ement
e
r M
a
n
Com
m
a
nual
Copyrigh
t
m
issio
n
h
t@2016 A
n
c
SiP
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.

Consult th
e dealer or an experienced radio/TV technician for help.
FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.

This transmitter must not be
co
-
located or operating in conjunction with any other antenna or
transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and opera
ted with
minimum distance 20cm
between the radiator &
your body.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
the maximum antenna gain allowed for use with this device is -2.5dBi
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM