User's Manual

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

CAS/Part No.9005000

- A non-threat intruder (other traffic symbol) at 3.6 NMI, 33

degrees left of the aircraft heading (approximately 11 o’clock),

1000 feet (304.8 meters) above, in level flight

- Red and green resolution advisory VSI overlay indicating a don’t

descend, don’t climb > 2000 feet per minute (609.6 meters per

minute) advisory

- TCAS TEST or RA OFF annunciation, depending on the

capabilities of the display.

- After 8 seconds, TCAS TEST PASS is announced, and the test

pattern is replaced with the normal VSI display.

- If self-test fails, TCAS TEST FAIL is announced, and TCAS FAIL

appears on the display. To obtain failure data, perform the

extended test mode procedure in the next section.

(b) TCAS Mode Activation

Prior to takeoff, activate TCAS as follows:

● Set TCAS/XPDR mode selector to TA/RA

● Set TA/DSPLY to AUTO

● Set ALT/RPTG to 1 or 2.

After clearing the runway following landing, set the TCAS/XPDR mode

selector to STBY to disable Mode S communication.

Figure 1-17: TCAS Display Test Pattern

Pub. No. 8600200-001, Revision 004

34-45-29

1-85

04 Nov 2014

Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.