User's Manual

SYSTEM DESCRIPTION AND INSTALLATION MANUAL
T
3
CAS/Part No.9005000
Table 4-1: T
3
CAS Computer Unit Interface Description (cont)
(Applicable to Part No. 9005000-10000, -10101, -10202, -10204, and -11203)
Connector
Pin
Designation
Functional Description
RTP-9K
Strobed Program Pin
Spare Or
DO-260B Config Data Parity (For Part No.-11203)
Refer to sub-section 3.B. TAWS/RWS/XPDR/DO-260B Data Configuration
RTP-10A
Discrete Input (Gnd/Open)
Glideslope Cancel (Self-Test)
RTP-10B
Discrete Input (Gnd/Open)
Audio Inhibit
RTP-10C
Discrete Input (Gnd/Open)
GPWS Inhibit
RTP-10D
Discrete Input (Gnd/Open)
Glideslope Cancel
RTP-10E
Discrete Input (Gnd/Open)
XPDR Air/Ground #1
RTP-10F
Discrete Input (Gnd/Open)
Terrain Display Select #1
RTP-10G
Discrete Input (Gnd/Open)
Terrain Display Select #2
RTP-10H
Discrete Input (Gnd/Open)
Landing Flaps / Landing Flap Override
RTP-10J
Discrete Input (Gnd/Open)
Steep Approach or Landing Gear Override. Refer to Note 7 following the table.
RTP-10K
Discrete Input (Gnd/Open)
Audio Momentary Suppress
RTP-11A
Strobed Program Pin
TAWS/XPDR #13: Terrain Adv Lines Displayed
Refer to sub-section 3.C. TAWS/XPDR Pin Programming
RTP-11B
Discrete Input (Gnd/Open)
WXR Radar #1 On/Off
RTP-11C
Strobed Program Pin
TAWS/XPDR #14: Eleview Function
Refer to sub-section 3.C. TAWS/XPDR Pin Programming
RTP-11D
Discrete Input (Gnd/Open)
WXR Radar #2 On/Off
RTP-11E
Discrete Input (Gnd/Open)
Terrain Mode Inhibit
Pub. No. 8600200-001, Revision 004
34-45-29
4-7
04 Nov 2014
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.