Operating & Installation Instructions for ACTpro MIFARE DESFire EV1 Readers 18-00072
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.0 Introduction: about MIFARE DESFire EV1 The ACTpro MIFARE DESFIRE EV1 cards are widely used in areas where security of the data is important. The technology is used in many areas such as access control, transport, cashless vending and logical access to name a few and it is an ideal platform for different vendors to store data for different applications.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.0 Reader Output Data Format Clock and Data The default data output format from the ACTpro MIFARE DESFire EV1 readers is Clock and Data encoded as 10 BCD digits (also known as Magnetic Stripe Track2 or ABA). Wiegand The reader can be configured to output Wiegand formatted data rather that the default clock & data, by connecting the Sense line to 0V before powering on the reader, this will switch the unit to 37bit Wiegand output mode.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.0 Wiring Information for “Wiegand” Output The standard Wiegand wiring colours for ACTpro MIFARE DESFire EV1 readers are shown below.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.0 Reader Configuration About DESFire EV1 File operation The default operation of all ACTpro MIFARE DESFire EV1 readers configured for file operation, to read the number that is encoded in a file on the ACT MIFARE DESFire EV1 cards, the number is also printed on the cards. About Serial and Reverse Serial operation When in Serial or reverse serial mode the MIFARE DESFire EV1 card serial number is read by the reader.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.0 Backlight Operation The ACTpro MIFARE DESFire EV1 1050 has backlight illumination of the keypad. Status LED operation on ACTpro MIFARE DESFire EV1 1030PM reader only The status LED can be disabled via jumpers on the ACTpro MIFARE DESFire EV1 1030PM only, the default operation is ON. The status LED is blue when in standby mode and goes Green or Red for access granted or Access Denied.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.
ACTpro DESFIRE EV1 Operating and Installation Manual Rev 1.
