Manual

www.acti.com
Hardware Manual
11
Installation Procedures
This section describes the procedures in installing the camera on a flat surface such as a hard or
dropped ceiling and straight or tilted walls. Before installation, make sure the wall or ceiling can
bear more than the weight of the camera.
Step 1: Prepare for Installation
1. Depending on the wall material, purchase applicable screws and screws plugs (as needed)
that can hold the camera and bracket weight on the wall.
2. Attach the supplied drill template sticker on the wall.
3. Determine how the cable will be routed: pass through the wall or along the wall.
 If the cable will pass through the wall, drill the cable hole and the three (3) screw
holes on the wall.
 If the cable will be routed along the wall, just drill the three (3) screw holes on the
wall.
4. Detach the drill template sticker from the wall and insert the plastic plugs into the screw
holes.
Cable hole