User`s manual

1.2 Preparation before setup

Our IP device provides access through Internet Explorer. You need to

set up the network settings and the IP address for the IP device. Please make

sure all connections are properly connected, then follow the procedures

below.

1. Setup your PC network

The IP address for your PC must be within the same subnet as the IP

device. You need to match the TCP/IP settings between PC and IP device

before you can access it via IE.

2. Setup IP device’s IP address

This IP device‟s IP address can be assigned manually or acquired

automatically by network service (DHCP). If it acquires the IP address by

using the DHCP service, please use the IP utility software bundled in the

product CD to find the IP address for all IP devices.

1.2.1 Setup your PC network

To set up the network of IP device via a PC, you have to change the

TCP/IP settings of the PC.

The following are the default network settings of IP device.

IP Address: 192.168.0.100

Subnet Mask: 255.255.255.0

To access the IP device, the IP address of the PC should match the

address below.

IP Address: 192.168.0.xxx

Subnet Mask: 255.255.255.0