Hardware Manual

1-8
4. Reset Button
Step 1: Switch off IP device by disconnecting the power cable
Step 2: Press and continue to hold the Reset Button (with a sharp
tipped object, like a pen.)
Step 3: Reconnect the power cable while continuing to hold the
reset button. The red Power LED light will flash on for 3 second
first, turn off for about 15 seconds, flash on for another second
and turn off again. By this time the reset to default operation is
already completed. This will take around 20 seconds from
power up. You may then release the reset button. This length of
time fluctuates slightly with the environment. The Power LED
light will come back on and stay on after a few more seconds. The
unit will start up with factory default settings automatically.
On (3s)
On
1s
Power On
About 20 Seconds
Stay On
Off (about 15s)
Off (10~15s)
Restore to Default
Complete
5. Conduit Hole
These conduit holes are used for cables to go through.