Hardware manual

www.acti.com

Hardware Manual

Installing the Camera on a Surface

This section describes the procedures in installing the camera on a flat surface such as a hard or

dropped ceiling and straight or tilted walls. Before installation, make sure the wall or the ceiling

can bear more than the weight of the camera.

Step 1: Drill the Holes

Before drilling the holes on the ceiling or wall, note the direction of the connectors side of the

camera, which is also the opposite side of the camera logo. This influences the camera

placement and where you should drill the hole where the cables will pass through or how the

cables will go along the ceiling or wall.

1. Use the supplied drill template to mark the screw holes on the surface according to the

preferred orientation.

2. Determine how the cables will be routed: pass through the surface or along the surface.

 If the cables will pass through the surface, drill the cable hole and the three (3)

screw holes on the surface.

 If the cables will be routed along the surface, just drill the three (3) screw holes on

the surface.

3. Insert the plastic plugs into the screw holes.

Cable hole