User`s manual

1. Reset Button

Step 1: Switch off IP device by disconnecting the power cable

Step 2: Press and continue to hold the Reset Button. Reconnect the

power cable while continuing to hold the reset button.

Step 3: Keep holding the reset button depressed around 6 seconds,

release the reset button. The unit will start up with factory default

settings.

2. Communication Switch Setting

The table below shows the function of each pin within the

Communication Switch.

Communication Switch Pin 1

Pin 2

RS-232 Setting (Reserved)

Pin 3

Termination

Pin 4

Line Lock

Pin 5

System Initialization (for

upgrade)

Pin 6

Reserved

RS-232 is reserved for internal use only; The Pin 3 and Pin 4, they

are used for termination and Link Lock adjustment respectively.

The Pin 5 is mainly used for return to factory default of camera

setting.

3. Dome ID Setting

Use the switch to change your speed dome ID by turning the