User`s manual

8
arrow to the desired number respectively. For instance, if the
speed dome ID is 123, the ID switch should be set as below:
centesimal decimal single digit
D
o
4. Dome Control Protocol
Protocol is a specific set of rules, procdures used for data
communications. Basing on the protocol of your management
software that you are going to use. Use the switch to set your
dome control protocol and the baud rate. Refer to table below and
turn the arrow to choose a protocol for your speed dome.
Switch No. Protocol Baud Rate
01
Pelco D 2400
02
Pelco P 4800
07
DSCP 9600
11
Pelco D 4800
12
Pelco D 9600
13
Pelco P 2400
14
Pelco P 9600
Select protocol: Pelco D, with switch no. 01 and baud rate 2400,
for instance, the ID switch should be set as below:
NOTE: If controlling through an ACTi decoder via analog
means such as a keyboard or DVR, no two speed domes
should be given the same ID or communication conflict may
occur. When controlled only through Ethernet and software
(without the use of an ACTi hardware decoder), the dome ID
setting may be neglected.
NOTE: The number “0” should locate upwards as shown in
above diagram for correct switch definition.