User`s manual

www.acti.com
Firmware User’s Manual V6.03.17
26
SNMP function is now enabled. You may now install and run the SNMP management software on
computer server.
SNMP Trap Usage:
SNMP traps enable notifications from devices. Devices may send message to the management
server whenever significant events occur such as cold start, warm start and authentication failure.
The manager will get the information immediately and take action if necessary.
Cold start means device reboot by power disconnection. Warm start means device reboot by
firmware without power disconnection. If there other parties attempt to connect to the device with
wrong security password under SNMP V1, V2 or V3 setting, the device will send an
authentication failure message to the management server.
To enable SNMP Trap function in the camera, type the IP address of the computer running the
SNMP management software and type trap community as password to allow server to get trap
message from device (Default is public). Select available traps and click “Apply”.
Camera’s SNMP offers following information:
Group
Description
System
Provide general information about the managed device.
Ex: system description, system name.
Interface
Provide general information from the physical interfaces.
Ex: interface speed, MAC address.
Address
Translation
Provide information about the mapping between network addresses and physical
addresses for each physical interface
Ex: The IP/MAC addresses to connect to the managed device.
IP
Provide the status and operation of Network Layer (Layer 3).
Ex: the information and traffic flow of received/delivered package.
ICMP
Provide the status and statistics of ICMP.
Ex: amount of receive/error message of ICMP.
TCP
Provide the status and operation of Transport Layer (Layer 4) using TCP protocol.
Ex: TCP Local Port, incoming/outgoing TCP segments.
UDP
Provide the status and operation of Transport Layer (Layer 4) using UDP protocol.
Ex: UDP Local Port, in/out datagram.
SNMP
Provide the related statistics through SNMP