User manual

ManualsBrandsACTi ManualsHome building and DecorD81

TD 92674EN

31 October 2013 / Ver. H

Configuration Manual

Ascom d81 DECT Handset

5 Handset Configuration

Figure 6. All Location Data

To configure the handset to provide both DECT and LF location data

simultaneously, perform

the following procedure:

1 Press the "Menu" soft key.

2 Select "Calls".

3 Select "Admin menu".

NOTE: The "Admin menu" is only visible if the Admin m

enu is a

ctivated. To activate

the Admin menu, see 6.1.1 Activating the Admin Menu on pa

ge 61

4 From the Admin menu, select "Location info".

5 Select "All Location info". Lo

cation information from both DECT and LF devices is

displayed in the handset display as shown in figure 6.

A handset configured to display both DECT location data and

LF location data shows the

following:

• L1- L4: Th

e four last valid location IDs. For DECT location devices, the location ID with

highest difference between the measured signal strength and threshold value is

regarded as the current location (L1). For LF location devices, the last received location ID

is regarded as the current location (L1). If the handset receives current locations from

both DECT location devices and LF location devices, the last received location is regarded

as the current location (L1).

Note:

No additional information is given whether the locations IDs ar

e received from a DECT

location device or LF location device.

DECT and LF Location Indications

When the DECT Location info, LF Loca

tion info or All Loca

tion info screens are setup, the

handset can be configured to provide additional indications to the support engineer as the

handset is carried into a valid location. A beep indication, a LED indication, or both can be

activated to indicate when valid locations are received. The activation parameters that can

be configured via the PDM/Device Manager are as follows:

Location > Indicate location with beep

• Off - The beep indication is turned off

• Beep on new - The handset beeps when it receiv

es a

new valid location. A location is

considered as "new" when the location ID is changed for the current location.

• Beep always - The handset beeps when it is receives a valid location.

Loca

tion > Indicate location with LED

• Off - The LED indication is turned off

12:34

Back

All Location info

L1: 0555, t1: 02118 s

L2: 0666, t2: 02115 s

L3: 0444, t3: 02168 s

L4: 0333, t4: 02103 s