User manual

TD 92674EN
31 October 2013 / Ver. H
Configuration Manual
Ascom d81 DECT Handset
38
5 Handset Configuration
• Alarm type for multiple press
Test alarm, Push-button Alarm 1, or Push-button Alar
m 2, or Not used. If Not used is
selected, the call after alarm number can still be dialled without sending an alarm, see
5.27.1 Call Predefined Number Without Sending Alarm on pa
ge 38.
• Text indication for alarm on multiple press
• Define multiple press
•ALS
1,2
• Silent alarm
1
If enabled, the indication of an alarm has been sent and received is disabled.
• Automatic call after alarm mode
The call can be established in the following mo
des;
- Normal: the call is established as an o
rdinary call.
- Loudspeaking: the loudspeaker on the backside of the handse
t is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to
an conversation.
See also 5.26 Common Alarm Settings on
page 36 for additional parameter settings.
Information about the handset’s location can also be sent along with an alarm, see 5.21
Base Station Location on page 32 and 5.22 DECT Location and LF Location on page 33.
5.27.1 Call Predefined Number Without Sending Alarm
The push-button can be configured to dial the automatic ca
ll after alarm number without
sending an alarm. The following example describes how to configure the push-button
(alarm on long press). The corresponding settings can also be configured for the push-
button when it is pressed twice or more (alarm on multiple press).
Example of configuration:
1 Select Alarm > Common
2In the Number for automatic call after alarm field, ente
r th
e number to be dialed.
3 Select Alarm > Alarm on
long press
4In the Alar
m type for long press drop-down list, select "Not used".
5In the Mode for autom
atic call after alarm drop-down list, select one of the following:
- Normal: the call is established as an o
rdinary call.
- Loudspeaking: the loudspeaker on the backside of the handse
t is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to
an conversation.
This configuration lets the user long press the push-button to dial
the number without
sending an alarm. However, the push-button can be configured to send an alarm by pressing
it twice (see Alarm type for multiple press in chapter 5.27 Push Button Alarm on page 37).
5.28 Pull-Cord Alarm
Note: Pull-cord alarm is not available when upgrading the product license from d81
Messenger to d81 Protector. That is, only applicable for d81 Protector with the No-
1. If the parameters "ALS" and "Silent alarm" are set, no ALS is triggered after an alarm has been sent.
2. The ALS is not activated if an automatic call is established after an alarm has been sent.