User manual

TD 92674EN
31 October 2013 / Ver. H
Configuration Manual
Ascom d81 DECT Handset
40
5 Handset Configuration
• Warning phase duration
Determines the time before the warning phase is ended and the alarm is se
nt.
• NM-MD extra delay used
Determines if detection time for man-down and no-movement a
larms are extended.
• NM-MD extra delay time
Determines how long time the extended detection t
ime is for man-down and no-
movement alarms.
•ALS
1
• Mode for automatic call after alarm
The call can be established in the following mo
des;
- Off: No automatic call after alarm
- Normal: the call is established as an o
rdinary call.
- Loudspeaking: the loudspeaker on the backside of the handse
t is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to
an conversation.
• Turn off NM-MD during call
Determines if the Man-down alarm and No-movem
ent alarm is disabled during a call.
See also 5.26 Common Alarm Settings on
page 36 for additional parameter settings.
Information about the handset’s location can also be sent along with an alarm, see 5.21
Base Station Location on page 32 and 5.22 DECT Location and LF Location on page 33.
5.30 Sound Settings for Calls
The ring volume and ring signal for calls can be set.
5.30.1 Set Ring Volume
1 Select Settings > Sound and Alerts.
2In the Ring Volume drop-
down list, select the ring volume to be used.
5.30.2 Set Ring Signal
1 Select Settings > Sound and Alerts.
2 In the call drop-down lists, select the ring signal to be used for the different calls.
3In the In
ternal
Call/External Call/Callback/PTT Call drop-down lists; select the ring
signal to be used for the incoming call, respectively.
Tip: Create own ring signals can be creat
ed and then selected. See 5.30.3 Create
Custom Sound as Ring Signal.
5.30.3 Create Custom So
und as Ring Signal
The handset can play customized ring signals. The ring signals mu
st first be customized
before it can be selectable in 5.30.2 Set Ring Signal.
NOTE: Custom sounds can also be used as message alerts.
It is recommended to not use
same sounds as ring signals and message alerts to distinguish them from each other.
For more information how to use custom sound as message alert, see 5.31.1
Configure Message Alerts with Be
ep
Codes on page 43.
1. The ALS is not activated if an automatic call is established after an alarm has been sent.