User manual

TD 92674EN
31 October 2013 / Ver. H
Configuration Manual
Ascom d81 DECT Handset
60
5 Handset Configuration
2 If the PBX is not configured to send display management text, but is configured to
send CLIP, CLIP is used to look up and resolve the calling party name from the local
phonebook. The handset can then display the name.
3 If no entry is found in the local phonebook
and th
e PBX is configured to send the
calling party name in CNIP, the name is taken directly from CNIP. The handset can
then display the name.
4 If the PBX is configured only for CLIP and no
nam
e resolution was possible because
the local phonebook had no entry corresponding to the calling party number, only the
calling party extension number can be displayed in the handset.
5.47.2 Display Manageme
nt
Parameter
If information about a caller exists in the loca
l phonebook, a display management parameter
can be configured to show this information in addition to the information provided by the
display manager. The additional information is displayed as additional lines of text in the
handset display. The parameter is accessed through the PDM/Device Manager by selecting:
Systems > System X > Display Management and Local Phonebook Name
The parameter can be set to one of the following values:
• Normal: The handset shows only the display management text.
• Add name internal and external ca
ll:
Additional detail about the caller is displayed if
there is information about the caller in the local phonebook. If there is no entry for the
caller in the phonebook, only the display management text is displayed. This option
applies when both internal and external calls are received.
• Add name external call: Displays additional caller det
a
il as described above, but only
when external calls are received.
5.48 Limit the Handset Output Power
The handset output power can, in certain situations, cause electromagnetic interference to
other sensitive electronic equipment. It may, therefore, be necessary to reduce the handset
output power when it is used around sensitive equipment. The output power can be reduced
by setting the value of the “Reduced power DECT output” parameter in the following way:
1 From the PDM/Device Manager select "Edit parameters"
2 Select Systems > Reduced power DECT output
3 Set the value of the "Reduced power DECT output" paramet
e
r to one of the following
values:
• Normal: The output power is not reduced and remains at 250 mW EIRP.
• Low: The DECT output power is limited to 100 mW EIRP.
• Very Low: The DECT output power is
li
mited to 50 mW EIRP
NOTE: Although this procedure can be used to limit the output power to the indicated levels,
the average output power is considerably less. For example, if the “Very Low” option is
selected, although the peak power is limited to 50 mW, the average output power is only 2
mW. This compares to an average output power of 10 mW if the output power is set to
"Normal".