Manual

www.acti.com
Firmware User’s Manual V7.00.44
25
 To directly go to the preset point, click the icon.
 To delete the preset point from the list, click the icon.
4. Repeat steps 2 and 3 to add more preset points to the tour.
5. Once done, click the Save button on Select a Preset Point.
6. On Touring Control, select the tour name to activate. Once activated, the camera will
start the tour.
NOTE: For PTZ cameras, ensure Auto Tracking is disabled to use Touring Control.
How to Use the Scan Function
The Scan Control page enables the camera to go from one predefined point to another by
scanning the view horizontally without losing focus. Unlike in preset tours, wherein the camera
goes to one preset point to another quickly and focusing only on the present point area, scan
function goes over point 1 to point 2 on a steady pace with the whole viewing angle in complete
focus. The scan speed can also be configured according to user preference.
Click the Scan Control page tab to configure scan function.
To set or modify scan points, do the following:
1. On Scan Points, click the icon of scan point 1 to set the scan starting point.
2. Pan and tilt on the area that you want to set as scan point 1.
3. Once done, click the icon again to close and complete first scan point.
4. Click the icon of scan point 2 to set the scan ending point.
5. Pan and tilt on the area that you want to set as the ending point.
6. Once done, click the icon again to close and complete scan point 2.
7. Select the preferred Scan Speed (the bigger the number, the faster the speed).
8. Select the preferred Scan Direction: Clockwise or counter-clockwise (this features is
available only in speed dome cameras.
Scan Direction
(Speed Dome only)
Scan Speed