Installation guide

www.acti.com

Installation Guide

2. Attach the bracket to the pole mount using the three (3) screws supplied in the pole mount kit.

Step 3: Remove the Pre-installed Network Cable (“Pigtail”)

1. Loosen the three (3) screws to detach the back cover.

NOTE: A cable is connected inside the camera; do not abruptly pull the back cover.

2. Disconnect the network connector (A) and remove the sealing nut (B).

3. Pull out the network cable from the back cover and disassemble the parts as marked below.

Sealing Nut

Claw

Seal

(A)

(B)