Quick Installation Guide

Before You Start
This guide contains all the information you need to quickly
setup the video decoder via local display interface. For
detailed information on installations or operations, please
refer to the Hardware Manual or User’s Manual on the ACTi
website (www.acti.com).
Before installation, prepare the following equipment:
1. Monitor (HDMI 1080p or Composite input)
2. HDMI cable or Video cable with BNC connector
3. RJ-45 network cable
4. Network switch
5. USB mouse
6. USB keyboard (optional)
7. Screwdriver
Step 1: Unpack the Device
Check if the package comes with the following items:
1. Video Decoder
2. Screw Pack
3. Cable Straps
4. Mounting Bracket
5. Power Adaptor
6. Terminal Block
The device can be mounted in three ways: Surface mount, Pole Mount or
VESA Mount.
Step 2: Mount the DeviceDevice Overview
1 2 3 4 5 6
8
7
1
Power LED
5
USB Port
2
System Ready LED
6
Ethernet Port
3
Reset Button /
NTSC and PAL Switch
7
HDMI Port
4
DC 12V Power Connector
8
Composite Port
1. With the smooth side
outwards, insert the cable
staps through the holes
(A-B-C-D).
NOTE:
• Use the inner A and D
holes if mounting on a
pole with 1” diameter or
the outer holes for a 2”
diameter pole.
2. Align the pole mount to the
pole.
3. Insert the cables through
the latches and push all the
wayuntiltheytsnuglyto
the pole.
4. Align the device to the
mount with the Ethernet
port side up and HDMI port
side down.
5. Secure the 4 supplied bolts
to attach the device to the
mount.
How to Use VESA Mount?
1. Place the device in between a VESA mount (10 x 10) and the
monitor, with the top side of the device facing the monitor while
the bottom side facing the VESA mount.
2. Attach the 4 supplied bolts to secure the device.
How to Surface Mount?
1. Using the supplied drill template, drill 4 holes on the surface.
2. Attach the 4 supplied screws to secure the device.
How to Use the Pole Mount?
A
B
C
D