User Manual
www.acti.com
ENR G3 Series System Administrator’s Manual
68
E-mail Settings
ENR supports e-mail notification for Event Handling sent through an SMTP server. To
enable this service, you will have to configure the SMTP mail settings in advance. For SMTP
service, please go to System Setup page System tab Network and make sure the
Default Gateway adopts the setting of the LAN connection that has access to the SMTP
server.
1. Go to System Setup System tab click “Email”.
2. Fill in every field according to the detailed instructions in the table below.
3. Click “Send Test Mail” to send a test mail to this e-mail account. If the test mail is
sent successfully, a message saying so will pop up, which means your ENR server is
ready to send out e-mail notifications when being triggered by an event.
4. Click “Save” to save these properties.
Field Name
Description
Sender Email
Input the sender’s e-mail address, should the same account you set for SMTP
server.
Server
Input the sender’s SMTP server address. Only alphabets, numbers, and the
symbols (.), (_), (-) are valid. ENR server supports the SMTP services with
SSL protocol. If you wish to use a free webmail SMTP service, you may
choose certain webmail providers such as Yahoo (SMTP:
smtp.mail.yahoo.com Port:25) or Gmail (SMTP: smtp.gmail.com Port:25 or
465 for SSL protocol / 587 for TLS protocol)
Port
Set the SMTP port, allowed value is from 1~65535, default is 25.
1
2
3
4