User Manual
www.acti.com
ENR G3 Series System Administrator’s Manual
81
Storage Settings
ENR keeps the recordings on SATA hard disks installed in it. Whenever recording is taking
place, ENR writes data to one of the disks, and switch to the other as the original one is full.
Once the available space of the whole system is less than the reserved size, ENR will start
deleting the oldest file to make the amount of space allowing each active channel to record
for another 10 minutes.
You may observe the disk memory and recording status on Storage page.
Go to System Setup click System tab click “Storage”. The connected storage
devices will be shown in the Storage Device list. Select a storage device to check its
Storage Information.
Storage Management
● SATA1 represents the disk installed in upper bay for saving recordings.
● SATA2 represents the disk installed in lower bay for saving recordings.
● Storage Media represents the connected USB disk that you inserted for carrying
firmware image file, backup file, exported system log file, snapshots or video.
The storage device only appears on the list when it is installed on the ENR.