User Manual

www.acti.com
KCM-7311 Hardware User’s Manual
15
How to Do the Waterproof Installation
The following installation procedure makes the camera be water-resistant even for the
situations where the camera can easily be flooded by pouring rain.
The important part to focus on during the installation:
The protection of the cabling has to be done by a proper flex
conduit. The size of the flex conduit that matches with the
conduit gland is is 3/4” (trade size), or with actual physical
diameter of 26.441mm.
Have the Ethernet cable inserted through the flex
conduit together with RJ-45 connector. You may also
consider to do the RJ-45 connector crimping after
pushing the cable through the conduit.
Disassemble the conduit gland.
Slide the clamping nut around flex conduit some 10-20
cm away from the top. Fit the sealing insert (made of
rubber) to the top of the flex conduit.
On the camera side, decide which of the 2 possible holes you are going to use to connect the
flex conduit. There is one hole on the side, and one on the bottom. Whichever you pick,
remember to seal off the other one with the metal patch (included in the camera set).