Hardware Manual

www.acti.com
Hardware Manual
16
Installing the Camera Using the Flush
Mount
This section describes the procedures in mounting the camera on a flat surface, such as wall
or ceiling, with the use of the bundled flush mount. This installation requires access to the back
of the surface. The main unit can be installed apart from where the camera is mounted, like in
a secured area or separate room.
Before installation, consider the following:
 Requires access to the back of the surface
 Supported surface thickness: 1 ~ 10 mm
 Supported lens hole diameter: 6 ~ 23 mm
 Camera cable length: 12 meters
 If there is another surface behind the back of the surface, must have space in
between of at least be 25 mm
 Mounting location of camera and the main unit can be separate
Step 1: Install the Flush Mount
1. Attach the bundled Flush Mount drill template sticker on the target installation surface.
Mark the area where the flush mount should me mounted.
2. Drill the lens hole (6~23 mm). The hole diameter will depend on how much of the lens will
appear from the other side of the surface.
3. After drilling the lens hole, remove the drill template.
Lens Hole
(Crosshair = centre of the lens)