Hardware Manual

www.acti.com
Hardware Manual
26
Connecting DI/DO Devices (Optional)
Depending on your surveillance needs, you may connect one (1) digital input and one (1)
digital output device to the main unit to trigger events or notifications.
Digital Input (DI) devices can be used to notify the camera about an activity in the camera site.
DI can be triggers of events. For example, you can connect a “panic button” to the camera; as
such when the panic button is pressed, the alarm signal will be sent through the camera. Other
common DI device applications are emergency button, smoke detector, passive infrared
sensor, etc.
Digital Output (DO) devices are external devices that are activated by the camera upon an
event inside the camera. For example, you can connect an “alarm horn” to the camera; as
such when an event occurs inside the camera (e.g. detected intruder), the alarm horn will
sound. Other common DO device applications are motion-triggered lights, electric fence,
magnetic door locks, etc.
1. Loosen the screws on the terminal block.
2. Connect the input/output pins to the corresponding pins on the terminal block, see
mapping table below.
3. Tighten the screws on the terminal block when done.
To connect an input device (DI), map the pins as below:
Device
Pin
Mapping Instructions
Digital Input (DI)
GND
Connect the wires of the digital input device to GND and
DI.
DI
To connect an output device (DO), map the pins as below:
Device
Pin
Mapping Instructions
Digital Output (DO)
12V
Connect the wires of the digital output device to 12V
and DO.
DO