VMGB-603 Installation Guide 2019/10/30
INSTALLATION GUIDE Thank you for purchasing ACTi products. The following documentation covers the installation and configuration of your device. NOTE: The accuracy of the analytics algorithm may be affected by different environmental factors or inappropriate installation. Please follow the procedures in this guide. ACTi will not be held liable for inaccuracies resulting from the aforesaid causes.
INSTALLATION GUIDE Examples of unsuitable scenarios: Backlight Insufficient Light Installation Height Requirements The camera should be installed in the front of the passageway where it can capture the face. The horizontal tilt angle of the camera must be less than < 25 °. 2. The camera installation must be elevated. This is to avoid the situation where a face is obscured by the person in front of him in case they go through the passageway closely one after the other.
INSTALLATION GUIDE 4. Make sure that there is no obstruction between the camera lens and the passageway. Examples of Standard Scenarios: Examples of Unsuitable Scenarios: Tilt angle is too large Elevation Capture The scenario is too wide Incline installation, with obstruction 4 www.acti.
INSTALLATION GUIDE The scenario is too large and the face recognition rate is low 5 www.acti.
Copyright © 2019, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C. TEL : +886-2-2656-2588 FAX : +886-2-2656-2599 Email: sales@acti.
