User's Manual

26
OVERHEAD DOME LIGHTS
The Dome Lights integrated into the unit are controlled by a three position slide switch. Sliding the switch to the ON position will turn
the lights ON. The OFF position will prevent the lights from turning ON with the vehicle's interior lighting. The AUTO position will allow the
lights to turn ON and OFF with the vehicle's interior lighting. Refer to the Installation Guide for wire connections. Do not leave the vehicle
unattended with the dome light switch in the ON position, as this could result in a discharged battery.
ACCESSORIES
WIRELESS HEADPHONES
SOURCE FEATURE
The ADVEXL10 includes a built-in infrared transmitter for use with the supplied wireless headphones. The headphone volume is adjusted
using the controls on each headset. Any number of wireless headphones may be used but they must be used within a line of sight from
the transmitter, as infrared transmissions, like visible light, travel only in a straight line. See the documentation accompanying your
wireless headphones.
Note: If the monitor is set to M2 mode, the headphones supplied with this unit will not work, as these headphones are single channel.
Only two-channel wireless headphones will work with this unit when set to M2 mode. The only time it is necessary to set this unit to M2
mode is if there is an RSA (Rear Seat Audio) installed in the vehicle or if two of these monitors are installed in one vehicle. Press the
system menu and highlight monitor mode to change the M1 mode to M2 mode or M2 mode to M1 mode.
AV
The AV input may be connected to a external video source, video game system, or other audio / video devices. To access the audio / video
inputs, inputs, turn the unit on and press the S (source) button or the Source button on the remote control until "AV” is displayed on the screen.
Turn the video source component on with its power button or remote control and it is now ready to play the audio and video signals from the
source connected to AV.
AUX
The AUX input may be connected to a external video source, video game system or other audio/video devices via AUX harness input, turn
the unit ON and press the S (Source) button or source button on the remote until “AUX” is displayed on screen. Turn the video source
component on with its power button or remote control and it is now ready to play the audio and video signal from the source connected
to AUX.