- Actiontec Wireless Ready DSL Gateway User Manual

19
Chapter 5 Basic Setup
The power LED flashes rapidly while the Gateway restarts, then glows steadily
green when fully operational. The Gateway is now configured and users can start
surfing the Web.
If an error stating the Web browser was unable to connect to the Internet appears,
check the configuration settings. Ensure all the information required by the ISP is
entered correctly.
Gateway Features
This section contains a quick description of the Gateway’s LEDs and switches.
Power LED - The Power LED displays the Gateway’s current status. If the Power
LED glows steadily green, the Gateway is receiving power and fully operational.
When the Power LED is rapidly flashing, the Gateway is initializing. If the Power
LED is not illuminated when the power adapter is plugged in, the Gateway has suf-
fered a critical error and technical support should be contacted.
Internet LED - When the Internet LED glows steadily, the Gateway is connected
to the ISP.
Wireless LED - When the Wireless LED glows steadily, the Gateway is ready for
wireless networking.
Ethernet Network LED - The Ethernet Network LEDs glow when a network link
is established with a computer. A flashing LED signifies network traffic across the
specific Ethernet connection.
Reset Switch - Depressing the reset switch for one or two seconds will reset the
Gateway. To restore the Gateway’s factory default settings, depress and hold the
Reset Switch for approximately 10 seconds.