- Actiontec Wireless Ready DSL Gateway User Manual

Appendix A Reference

easiest way to do this is to purchase a pair of two-line modular adapters, a line-

cord coupler, and some short lengths of phone cable, available at any telephone

supply retailer.

☞

Note:Do not purchase a 1-line modular adapter or line splitter.

Installing either of these items results in two phone jacks on

Line 1, and no access to Line 2.

1. Disconnect the telephone from the two-line phone jack.

2. Install one of the two-line modular adapters (modular adapter #1) in the

phone jack

3. If Qwest DSL is on Line 1, install the phone filter in the Line 1 jack of modu-

lar adapter #1.

4. Install a short length of phone cable between the phone filter and the Line 1

jack of the other two-line modular adapter (modular adapter #2).

5. Install a short length of phone cable between the Line 2 jacks of modular

adapters #1 and #2.

6. Connect the line-cord coupler to 2-line modular adapter #2.

7. Install a short length of phone cable between the line-cord coupler and the

telephone.

If Qwest DSL is on Line 2, use the same procedure, but install the phone filter on

Line 2.

Security Alarm System

If the user plans to connect Qwest DSL at a location that has two phone lines, Qwest

DSL must be installed on the phone line that does not service the alarm system.

If the alarm system and Qwest DSL must share the same phone line, contact Qwest

Sales to order a technical install. Special wiring needs are required when Qwest

DSL and the alarm system share the same phone line. Qwest Sales telephone num-

bers are listed at the back of this manual.