User Manual

WPB3000 Powerline Wireless Network Extender User Manual

 Note:

The LAN user is allowed to access the Powerline Wireless Network Extender

by user names and passwords (admin/admin).

5.2 Using WPS clone to sync WPB3000

If you want to sync WPB3000 wireless configuration parameter from uplink Router,

you can consider WPS clone function. Steps as followed:

Step 1 Press“WPS”buttonover10s,until“Wireless”LEDblinkwithREDcolor.Ifthe

devicehassuccessfullyclonedthewirelessconfigurationparameterfrom

Router,thenthe“Wireless”LEDwillblinkwithorangecolor.

Ifthesynchronizationfailed,the“Wireless”LEDwillblinkwithREDcolorwithhigh

frequency.Then

youcansetthesamewirelessconfigurationparameterasRouterinthe

websiteasbelow:

Step 1 OpentheIEbrowser,andenterhttp://192.168.10.1

intheaddressbar.

Note:WhentheWPB3000isconnectedwiththeuplinkrouterandDH CPserver

openinuplinkrouter ,pleaseuse“http://myextender”



Step 2 Inthefollowingpage,youcansetwirelessconfigurationparameterofthe

Router(eg,SSID,securitymode,password),andthenclick“Apply”.