User Manual

Button
Security: Set the status of device members.
Reset: Restore factory default settings.
WPS: Press this pushbutton for less than 3 seconds to
enable the negotiation of PBC mode. Press this
pushbutton for more than 5 seconds to enable or
disable WLAN.
Software Upgrade Support software upgrade by Web page.
Consumption 6.5W
Environment Requirements
Operating
Temperature
0~40ºC
Storage
Temperature
-10~70ºC
Operating
Humidity
10%~85%, non-condensing
Storage Humidity 5%~90%, non-condensing
Rated Input 100~240 V AC, 50/60Hz
EMC and Safety
Compliance FCC Part 15 Class B, CE
Safety
Authentication
UL
Green Standard RoHS
Physical Characteristics
Dimension L × W × H: 107mm × 62mm × 48.5mm
Weight 180g
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following
measures:· Reorient or relocate the receiving antenna.· Increase the separation between the
equipment and receiver.· Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.· Consult the dealer or an experienced radio/TV technician
for help.FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Industry Canada Statement:
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions: 1) this device may not cause interference and 2) this device must
accept any interference, including interference that may cause undesired operation of the