Owner's Manual

Installing Communications Software

If your modem came with a communications software package, it is strongly recom-

mended that you use this software for your modem. It has been specially configured

to work with this modem. If communications software came with this modem, the

Users Guide for this software can be found on the installation CD-ROM.

If you wish to use another software package, please be sure that it supports this mo-

dem. Most Software Manufacturers have a listing of supported modems on their

websites or BBSs. Check these sites to see if this model is supported. If you are unsure

or your brand of software supports only a few modems, try selecting “Hayes Com-

patible” or “Standard Modem”. This may work in certain cases.

Some software programs allow manual input of parameters. For the users of these

programs, here is a listing of the Data/Fax/Voice Command Standards supported.

Data: TIA/EIA-602

Fax: TIA/EIA-578 for Class 1 Fax

Voice: TIA IS-101 support for TAD (Telephone Answering Device)

Init String: AT&F&C1&D2W2

TIA IS-101 Commands not supported:

Caller ID

Full Duplex Speakerphone

VoiceView

Note: some programs must be configured to communicate with the modem on the

same COM port and or IRQ setting used by the modem. See “Installing the Mo-

dem” section for instructions on how to determine your COM Port and IRQ set-

tings.