Owner's Manual

sources. The modem needs one IRQ and one COM Port in order to function. (Read

your computer user’s manual for information on how to invoke and use the BIOS

setup).

Inside your computer’s BIOS Setup, find the Plug-N-Play configuration. This can be

found within a section titled “Advanced”, “PNP/PCI Configuration”, or “Plug and

Play Configuration” depending on the BIOS Manufacturer. Next, from the informa-

tion you noted in Step 2, find the interrupt selection for the IRQ your modem is

using (some BIOS don’t allow individual selection of interrupts to ISA, Plug-N-Play,

or PCI). You want to set this to a Plug-N-Play setting. This can be called ICU/PCI,

ISA, or PNP depending on your BIOS version and manufacturer. Do not set this

interrupt to “PCI” only or to “Legacy ISA”.

If you do not have any free interrupts available, you will have to disable some unused

function of your computer system. If you are using a PS/2 style mouse, you probably

can spare one of your internal COM Ports. To disable a COM Port, find the BIOS

Setup section for “Integrated Peripherals”. Locate the serial port settings and disable

an unused port that has nothing connected to it (usually serial port 2.) This should

free one IRQ for your modem to use. You may also have to disable the COM Port in

Windows 95.

Under some situations, you will find that freeing an interrupt does not solve your

installation difficulties. This could be due to another peripheral device stealing the

interrupt you just provided.

Certain full-featured sound cards require three IRQs to support all their functions.

This situation requires that you remove your sound card, make an interrupt avail-

able, install the modem and verify its operation, and then reinstall the sound card.

This procedure may also work for sound cards that have lost their sound after the

modem has been installed or if the modem will not install in a system with a sound

card.

Common Problems

No Dialtone Error

Make sure you have connected the phone cable into the right connector on the back

of the modem. See Figure 7: Connecting Devices.

You may have too many devices connected to the phone line. Remove all other equip-

ment.

Your modem may not recognize overseas dialtone. Use the AT Command ATX0

(See Appendix B: AT Commands) to have the modem ignore the dialtone before

dialing.