Owners manual

3
firmware update is available. See "Updating MyWirelessTV Firmware" for more details.
 OTG port. Reserved for USB Backchannel feature.
Transmitter Rear Panel
 Power port. The 5V DC / 2A power port is used to connect the Transmitter to a power
source.
 HDMI Input port. The HDMI Input port is used, via an HDMI cable, to connect the
Transmitter to an HDMI source (set top box, Blu-ray player, gaming console, etc.).
 HDMI Out to TV port. The HDMI Out to TV port (a pass-through port) is used, via an
HDMI cable, to connect the Transmitter to a local HDTV to allow continued video
viewing on the monitor located nearest to the Transmitter. Connection to this port is
optional.
 IR Transmit port. The IR Transmit port is used to connect the IR Blaster cable to the
Transmitter, enabling the use of the source device remote control in tandem with
MyWirelessTV.
1.4.2. MyWirelessTV 2 Receiver
The MyWirelessTV 2 Receiver features four ports (Power, HDMI Out to TV, IR Ext, and
USB), two buttons (MENU and SELECT), and three LEDs (MODE, LINK, and POWER).
Receiver Front Panel
 MODE LED. Reserved.
 LINK LED. The LINK LED is used to display the state of pairing between the
Transmitter and Receiver. If it is blinking or off, the Transmitter is not paired with any
Receiver. If it is glowing steadily, it has paired with a Receiver.
 POWER LED. The Power LED is used to display the state of the Receiver's power. If
unlit, the device is off. If lit, the device is on.
 USB port. The USB port is used to connect a USB stick drive to the Receiver when a
firmware update is available. See "Updating MyWirelessTV Firmware" for more details.
 MENU and SELECT buttons. The MENU and SELECT buttons are used together to
access the GUI menu. Pressing the MENU button selects an option, and pressing the